[Moon] DL4MEA Cable prblm.

[jimmyv at hol.gr]

Typing error, voltage cable i recently changed is 3*2.5mm (not 3.5mm  
diameter) for a 36+m run.
Rest below is as described.

73
Jimmy sv1btr

> Hi Guenter & all
>
> I had the same problem with you on 70 & 23cm, a 3V loss for
> relays/preamps, using rg-58 of bad quality but also drawing 1.2A and
> 400ma current respectively over a long cable run of 30m+.
> Bought electrical copper cable 3*3.5mm, put 2*3.5mm for + in parallel
> and problem solved. Cost was less than the vy expensive rg-58, for the
> electrical cable was 1.2e/m
> Even 2*3.5mm cable would have done the job.
>
> Protecting preamps with special, fast surge protectors at voltage feed.
>
> 73
> Jimmy SV1BTR
>
>> HI G?nther,
>>
>> To feed your system, I can understand you have large cable losses due. to a
>> high DC Current.
>>
>> I will recommend you to use the coaxil cable  RG8 / 213 / two in parallel
>> or 1/2"  it is much more useable .
>> and it can easily handle the current.
>>
>>
>> Its my guess.
>>
>>
>> Gr?sse und vy 73 von OZ5IQ, Kim
>>
>>
>>
>> _______________________________________________
>> Moon mailing list
>> Moon at moonbounce.info
>> http://www.moonbounce.info/mailman/listinfo/moon
>>
>>  Please enter/update your standings:
>>  http://www.vhf-dx.net/top.html
>>
>>  When you decide to remain anonymous I may consider this unpolite
>> and remove you from the list
>>
>>
>
>
>
>
> _______________________________________________
> Moon mailing list
> Moon at moonbounce.info
> http://www.moonbounce.info/mailman/listinfo/moon
>
>  Please enter/update your standings:
>  http://www.vhf-dx.net/top.html
>
>  When you decide to remain anonymous I may consider this unpolite   
> and remove you from the list
>
>